| Specifications for Type "B" Dust Collectors |
|
Standard Specifications |
| Free Standing |
| Weatherproof |
| Painted, Prime & Finish Coats |
| 14 Gauge Steel Construction |
| Polyester Filters with Snap-On Rings |
| TEFC Motors |
| Flexible Drum Sleeves with Quick Disconnect Clamps |
| (1) Hinged Access Door to Filter Section |
| Sprinkler Connector |
Choice
of Orientation for the following:
|
For inside locations having a light to medium dust load, we recommend our KTM "B" Type Dust Extractor, which is available from 5 HP to 30 HP. This model features a motorized filter shaker. Filter area can be designed to your specific requirements. Units have 4 to 8 fabricated sheet metal barrels with either rubber or terylene needle felt connector sleeves. Model "B" is specially suited for wood dust, rubber, plastic, paper, ceramic and metal dusts. Unit sizes may be altered without extra charge to your space and location.
Features:
High
efficiency ¤ Easy removal of collected material ¤ Self contained ¤ For
outside and inside use ¤ Low cost ¤ Primary separation ¤ Secondary filtration
through bag filters ¤ Clean air outlet.
Operation:
Material
enters unit at primary separation section where the heavy particles settle to
the lower storage drums. The fine material flows upward into the filter
bag section and are shaken down after each operation cycle. Clean air
passes through the filter media into the atmosphere or can be returned to the
manufacutring area. Prices are available upon request. Also
available as options are hoods, ducts and installation. NOTE: Electrical
switches and connections are not included.